Isolbet - DYSPERBIT dispersion asphalt rubber compound

For renovation and maintenance of roofing exclusively from asphalt roofing felt, making roofless roofing without undercoating on one layer of roofing felt. For decorative and protective coatings on asphalt roofing sheets, priming substrates and foundation insulation. ATTENTION! Use cold. Use outdoors. Protect from frost!

Method of use

Mix thoroughly before use. Apply to a dry, cleaned surface in wet weather, at ambient and surface temperature from +5 C to +30 C and humidity not higher than 65%. Apply with a putty knife or brush. Before applying the coating, the surface should be primed with 1: 1 diluted mass. The mass is applied in a layer about 1 mm thick. Each subsequent layer (the coating should be made of at least 2 layers) is applied after the previous one dries. The time it takes to form the coating depends on the prevailing conditions (approx. 6 hours at 23 2 C). The coating should be protected against moisture until it dries. If you use Dysperbit for roofing maintenance, apply topping on top of the fresh layer. Coverage: Approximately 1 kg / m2 with one coat. Proper moisture protection is obtained with a consumption of min. 2 kg / m2.

The product is packed on returnable pallets (paid).