weber.tec 827 S (Superflex 40 S) is a two-component sealing resin used for sealing horizontal, vertical and sloping surfaces. Special product properties:
- very good adhesion to the ground,
- crack bridging ability,
- waterproof,
- flexibility,
- resistance to heat and frost,
- resistance to aggressive media effects.
properties
Flexible, reactive epoxy resin for under-tile sealing coatings
- very good adhesion to the ground
- ability to bridge fig
- waterproof
- flexibility
- resistance to heat and frost
- resistance to aggressive media effects
Application
weber.tec 827 S (Superflex 40 S) creates a flexible and tight membrane, directly under the ceramic cladding. Its areas of application are:
- swimming pools,
- brine and thermal pools,
- wet rooms additionally loaded with aggressive media (kitchens in mass caterers, rooms in butchers, slaughterhouses, car workshops, etc.),
- laboratories.
The product can also be used as a tile adhesive (after adding 3 4% by weight thickener - quartz sand) and to protect and / or seal flashings on balconies and terraces. The strip sheets must be firmly connected to the ground with dowels. Weber.tec 827 S (Superflex 40 S) can be used on:
- concrete / reinforced concrete base,
- traditional (cement) plasters,
- cement screeds,
- existing, stable ceramic cladding (glazed and unglazed),
- ground asphalt (indoor).
Weber.tec 827 S (Superflex 40 S) resin should not be used on existing ceramic cladding in the outdoor area (e.g. balcony and terrace surfaces) that are above heated or inhabited rooms.
In the kitchens (except the kitchen stalk
and an outlet gutter), in laboratories
and wet rooms wear
weber.tec 827 S (Superflex 40 S)
is: | 1.5 kg / m2
(layer thickness 1.2 mm) |
In pools and kitchens (in between
kitchen stem and drainpipe)
weber.tec consumption 827 S.
(Superflex 40 S) is: | 2.5 kg / sq m
(layer thickness 2 mm) |
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent