Sopro - RAM3 454 leveling and renovation putty
Price:
zł84.89
Tax included
A stable, gray plaster and putty compound used for quick leveling, modeling and repair of wall and floor surfaces. It has very good working properties.
Stable, gray plastering mortar and putty for quick leveling, modeling and repair of wall and floor surfaces. Characterized by very good working properties.
Features
- the possibility of laying tiles after 2 hours
- highly crystalline water binding
- for heated floors
- easy execution inheritance
- to the swimming pool in
- frost-resistant
- waterproof
- very low VOC emissions
- low chromate content in
- for floors, walls and ceilings
- layer thickness 3–60 mm
- inwards and outwards
Application
- plastering, leveling, smoothing, modeling and repair of wall surfaces, ceilings, concrete floors, brick walls, sand-lime block and mixed wall
- making vertical and horizontal as well as smooth substrates for composite seals, natural stone and concrete slabs, ceramic cladding and other floor and wall coverings
- renovation and quick repairs thanks to the properties that facilitate filling the cavity and modeling
- for plastering plinth
- as plaster and leveling compound for leveling the substrate, making coves and producing sloped surfaces on load-bearing substrates
- for indoor and outdoor use
- in swimming pool basins, in damp and wet rooms, on stairs, balconies and terraces
- for heated floors and walls
Technical data
- mortar from the CS IV group in accordance with PN-EN 998-1, based on Portland cement, selected mineral aggregates and special polymer in
- layer thickness from 3 mm to 60 mm in one work cycle
- mixing ratio 4.25-4.75 l of water: 25 kg Sopro RAM 3
- maturing time 3-5 min
- efficiency from a 25 kg bag: approx. 15.5 l of fresh mortar; respectively, with a layer thickness of 10 mm 25 kg sack of dry mortar is enough for approx. 1.7 m 2 surface plastered
- use time approx. 20 minutes
- cladding works possible: after approx. 2 h at +20 C; after 24 h at +5 C
- application temperature from +5 C to maximum +35 C (substrate, air, material)
- consumption approx. 1.5 kg / m 2 per 1 mm of the layer thickness; as a mortar to make facets 0.4-0.5 kg / rm
- package 25 kg
5 other products in the same category
Sopro - epoxy varnish for high-strength concrete SoproDur HF-L 513
zł415.09
Rated out of 5 stars based on
review(s)
Sopro - polyurethane adhesive component A + B PUK 503
zł221.71
Rated out of 5 stars based on
review(s)
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent