STYRPAPA sandwich panels are EPS 100 - 038 ROOF-FLOOR expanded polystyrene boards, coated on one side or both sides with roofing felt on glass veils of the type P64 / 1200 or P-100/1200. They are designed for thermal insulation of flat roofs. They can be laid on the following types of substrates: concrete, flat, cement mortar, trapezoidal sheets, existing roofing STYRPAPA boards are attached to the ground (depending on its type) using a mechanical fastener (concrete, wood, trapezoidal sheets) or using glue in intended for gluing foamed polystyrene (concrete and tar paper) approved for use in construction. The adhesive should be applied directly to the surface. The surface of the substrate should form a flat plane. In the case of mineral (concrete and cement mortar) and tar surfaces, it is recommended to prime the surface with bituminous agents that do not destructively affect foam. STYRPAPA panels can be prepared in the form of sloping panels, enabling the desired shape of the roof slope. In addition, they have a projection of the top layer of roofing felt beyond the edge of the board with a value of 5 cm, constituting the assembly plant.
attention
It is possible to laminate the other side - price on request. In the commentary to the order, please specify the dimensions of the panels. Available dimensions:
- length: 1000 mm, 1500 mm, 3000 mm
- width: 500 mm, 1000 mm
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent