Drizoro - Maxbeton, quick-setting and shrink-free hydraulic repair mortar

Maxbeton is a quick-setting, shrink-free hydraulic mortar for repairing water-conducting defects under low pressure. It is available as a one-component product, to be mixed only with water.

Technical data

• gray powder
• apparent density of the powder 1.25 g / cm ³
• pH 11.5
• mixing water (up to weight) 20-21%
• apparent mortar density 2.10 g / cm ³
• mixing time (at +20 C) 4-5 min
• setting time (at +20 C) 7-10 min
• time between coats (at +20 C) 5-6 min
• frost resistance tested after 200 freezing and thawing cycles (according to IBDiM No. PB / TM-1/12 procedure): weight loss up to 5%; decrease in bending strength up to 20%; decrease in compressive strength by up to 20%
• adhesion to the substrate, pull-off method, 1.68 MPa after frost resistance test
• fresh mortar consistency 10-12 cm
• consumption approximately 1.8 kg / l
• approximate filling after 1 kg of the product is consumed 0.55 l

Application

• sealing, repairing water-conducting defects under low pressure
• anchoring the element in plastic and metal, in concrete, masonry, cement plaster
• sealing around pipes and draining in cisterns, water tanks etc.
• laying and attaching covers and drain grates
• application on horizontal and vertical planes

Maxbeton is an expansive mortar - the volume increases during setting. It does not contain chloride and does not cause corrosion.